|
|
.
.
.
|
|
Instructions for operation:Fill the 1.25 liter tank with standard (water based) fog fluid. There is a tube that leads from the top of the tank into the machine (make sure it's suction end rests at the bottom of the fluid tank). Flip the power switch that is on the rear of the unit to the "On" position. The switch lights up red and begins the initial warm up time of about 3 minutes. The wired 16' controller plugs into the 5 pin input on the rear of the unit.The controller consists of 3 buttons with different color LED indicators above each button. The buttons control the modes and the 3 knobs above the buttons control the features in each mode. |
 |
| Timer
Mode: The left button, marked "Timer," lets you set the fogger to to dispense fog in certain set intervals. Use the knob marked "Interval" to adjust time between blasts. The interval knob goes from 10 seconds to 200 seconds. 10 seconds being all the way to the left, turn clockwise to increase the time between blasts. Use the "Volume" knob to set the output to desired volume. |
 |
| Manual
Mode: The right button is the "Manual" fog button. The green button has the green light above it to let you know when the fogger is ready to dispense fog (after each complete burst the green light will go off until the fogger has reheated). You cannot control the output in Manual Mode. |
 |
| Continuous
Mode: The middle button is the "Continuous" fog button. In this mode as soon as the fogger has reached it's ready temperature the it will automatically start blowing fog. The knob above marked "Volume" controls the amount of fog that it dispenses starting. All the way to the left is none and turn clockwise to desired output. |
 |
| DMX Mode: Connect the 127-haze1200dmx to your controller by DMX cable adjust the dipswitches on the back of the hazer. The hazer is 1 channel and that slider controls the output. Bring the slider all the way down to cut off the fogger. |
 |
| Includes black power cord. |  |
