|
|
.
.
.
|
|
Instructions for operation: |
 |
| Fill the 1.25 liter tank with standard (water based)
fog fluid.
There
is a tube that leads from the top of the tank into the machine (make
sure it's suction end rests at the bottom of the fluid tank). Flip the
power switch on the rear of the unit. The switch lights up red and
begins the initial warm up time of about 3 minutes. The 16' wired
controller plugs into the 5 pin input on the rear of the unit. Adjust
the vent in the front of the unit to disperse fog straight out along
the ground or adjust it up to spray fog into the air. The controller consists of 3 buttons with different color led indicators above each button. The buttons control the modes and 2 knobs above the buttons control the features in each mode. |
 |
| Manual
Mode The green button is the manual fog button. The green button has the green light above it to let you know when the fogger is ready to dispense fog (after each complete burst the green light will go off until the fogger has reheated). You cannot control the output in manual mode. |
 |
| Continuous
Mode The (middle) red button is the continuous fog button. In this mode, when the fogger has reached it's ready temperature, the it will automatically start blowing fog. The knob above marked "Volume" controls the amount of fog that it dispenses. All the way to the left is none and turn clockwise to desired output. Always start with the volume knob fully clockwise and gradually turn the knob counter-clockwise because the fog decreases to zero slightly before the knob reaches full off, (full counter clockwise). |
 |
| Timer Mode The yellow button marked "Timer" lets you set the fogger to to dispense fog in certain set intervals. Use the knob marked "Interval" to adjust time between blasts. The interval knob goes from 10 seconds to 200 seconds. Ten seconds is all the way to the left, turn clockwise to increase the time between blasts. Use the volume knob to set the output to desired volume. |
 |
| Includes black power cord. |  |
