|
|
.
.
.
|
|
Instructions for STAND ALONE operation: |
 |
|
Place dip switch #10 in the on/down position. This will initiate stand alone mode and the LED bar with begin to run through it's pattern's. Dip switch #7 and #8 control the speed of this mode. With only dip switch #10 on/down the light rolls through it's pattern's quickly. Put dip switch #7 on/down to slow the pattern change. Put dip switch #8 on/down to get the slowest setting. |
 |
| Instructions for Sound Mode: Make sure all dip switches in the off/up position. This will initiate sound active mode. Adjust the knob on the rear of the unit to your desired sensitivity. |
 |
|
Instructions for DMX MODE: Channel #1 controls on/off. Value 2-249 is strobe going from slow to fast. The slider all the way up is intensity full. Channel #2 controls the red LED's intensity Channel #3 controls the green LED's intensity Channel #4 controls the blue LED's intensity Channel #5 controls the preset patterns Channel #6 controls the speed of the preset patterns from fast (down) to slow (up) |
 |
| Instructions
for Master/Slave
MODE: Set the first fixture to any stand alone function. Connect the second fixture by DMX cable and set the #1 dip switch to on/down and the two fixtures will sync up. |
 |
| Includes attached black power cord. |
 |
