Instructions for operation:
Fill
the 1.25 liter tank with standard (water based) fog fluid. There is a
tube that leads from the top of the tank into the machine (make sure
it's suction end rests at the bottom of the fluid tank). Flip the power
switch that is on the rear of the unit to the "On" position. The switch
lights up red and begins the initial warm up time of about 3 minutes.
The wired 16' controller plugs into the 5 pin input on the rear of the
unit.
The controller consists of 3 buttons with different color LED
indicators above each button. The buttons control the modes and the 3
knobs
above the buttons control the features in each mode.
|
 |
Timer
Mode:
The left button, marked "Timer," lets you set the fogger to to dispense
fog in certain set intervals. Use the knob marked "Interval" to adjust
time between blasts. The interval knob goes from 10 seconds to 200
seconds. 10 seconds being all the way to the left, turn clockwise to
increase the time between blasts. Use the "Volume" knob to set the
output to desired volume.
|
 |
Manual
Mode:
The right button is the "Manual" fog button. The green button has the
green light above it to let you know when the fogger is ready to
dispense fog (after each complete burst the green light will go off
until the fogger has reheated). You cannot control the output in Manual
Mode.
|
 |
Continuous
Mode:
The middle button is the "Continuous" fog button. In this mode as soon
as the fogger has reached it's ready temperature the it will
automatically start blowing fog. The knob above marked "Volume"
controls the amount of fog that it dispenses starting. All the way to
the left is none and turn clockwise to desired output.
|
 |
DMX Mode:
Connect the 127-haze1200dmx to your controller by DMX cable adjust the
dipswitches on the back of the hazer. The hazer is 1 channel and that
slider controls the output. Bring the slider all the way down to cut
off the fogger.
|
 |
| Includes black power cord. |
 |
