Instructions for operation:
|
 |
Fill the 1.25 liter tank with standard (water based)
fog fluid.
There
is a tube that leads from the top of the tank into the machine (make
sure it's suction end rests at the bottom of the fluid tank). Flip the
power switch on the rear of the unit. The switch lights up red and
begins the initial warm up time of about 3 minutes. The 16' wired
controller plugs into the 5 pin input on the rear of the unit. Adjust
the vent in the front of the unit to disperse fog straight out along
the ground or adjust it up to spray fog into the air.
The
controller consists of 3 buttons with different color led indicators
above each button. The buttons control the modes and 2 knobs above the
buttons control the features in each mode.
|
 |
Manual
Mode
The green
button is the manual fog button. The green button has the green light
above it to let you know when the fogger is ready to dispense fog
(after each complete burst the green light will go off until the fogger
has reheated). You cannot control the output in manual mode.
|
 |
Continuous
Mode
The
(middle) red button is the continuous fog button. In this mode, when
the fogger has reached it's ready temperature, the it will
automatically start blowing fog. The knob above marked "Volume"
controls the amount of fog that it dispenses. All the way to the left
is none and turn clockwise to desired output. Always start with the
volume knob fully clockwise and gradually turn the knob
counter-clockwise because the fog decreases to zero slightly before the
knob reaches full off, (full counter clockwise).
|
 |
Timer Mode
The
yellow button marked "Timer" lets you set the fogger to to dispense fog
in certain set intervals. Use the knob marked "Interval" to adjust time
between blasts. The interval knob goes from 10 seconds to 200 seconds.
Ten seconds is all the way to the left, turn clockwise to increase the
time between blasts. Use the volume knob to set the output to desired
volume.
|
 |
| Includes black power cord. |
 |
