HIGH
PASS crossover with a 4k Hz crossover point and 18dB per octave slope.
Handles 300 watts continuously and 600 watts peak. All components are
mounted on a PC board with mounting holes in all 4 corners. No wires
attached. You will need to solder wires to this crossover. This is a
much higher quality crossover than most others because the "norm" is to
have a 6dB or 12 dB per octave slope and this has 18. This provides
MUCH more protection for any horn driver. Size: 4.25" x 3.5" x 1.5"
High
power 2-way crossover. 4000 Hz cut off, 18 dB per octave. 500 watts
continuous. **NO CONNECTING SPADES, speaker
wires must be soldered to the board.** Size: 5.5" x 4.25" x 1.75"
HIGH
POWER!! 800 watt 2 way crossover with lamp fuse protection built in!
Crossover point is 3,000 Hz. Sloping ratio is 18dB per octave. There
are no wires attached to this crossover. It has standard 1/4 inch spade
lugs. You will need to use standard spade connectors or solder wires to
it for all connections. Mounting holes in all 4 corners. Size: 7" x 3"
x 1.25"
High
power 3-way crossover. High pass is 8000 Hz, mid is between 8000 and
4000 Hz, and low pass is 4000 Hz. 18 dB per octave. 500 watts
continuous. Size: 5.5 x 4.25 x 1.75. **NO CONNECTING SPADES, speaker
wires must be soldered to the board.**
Low pass crossover for subwoofer cabinets. 125 Hz, 500 watts, 12 dB per
octave slope. **NO CONNECTING SPADES, speaker
wires must be soldered to the board.** Mounting holes in all
4 corners. Size: 3.5" x 3" x 1.75"
24
inch wires to connect crossover to horn or woofer. Medium female spade
lugs on one end to connect to crossover. Small spade lugs on other end
to connect to woofer or horn driver.
36
inch wires to connect crossover to horn or woofer. Medium female spade
lugs on one end to connect to crossover. Small spade lugs on other end
to connect to woofer or horn driver.
